Rate testing step for research on sodium ion battery MoS2-based anode material
Latest updated: May 15, 2024 Video recording version: 8.0.0.516, compatible with BTS 8.0 software.
Open the pre-set rate work step file.
First set aside for 3 hour to allow the battery to stabilize internally.
Since the study is on anode materials, the constant current discharge step is set up first.
After selecting the multiplier mode, enter a nominal specific capacity of 670 mAh/g and an activator mass of 2 mg.
According to the literature, the embedded sodium potential of MoS2 is mainly in the range of 0.5~1.0V.
Therefore, a voltage window of 0.1~3.0 V was chosen to cover the embedded sodium potential range of MoS2.
Set the magnification gradient to 0.1C, 0.2C, 0.5C, 1C, 2C, 5C, 0.1C.
Setting multiple magnification gradients is conducive to a more comprehensive evaluation of the performance and stability of the battery at different magnifications.
10 cycles at each magnification.
Provides a relatively comprehensive evaluation of the battery, saving time and resources.
Rate parameters can be set according to requirements.
The above demo parameters are for reference only, please refer to your own experiments.
After setting the parameters of the work step, just click start.
